GW Instek PSW Series - Configure Ethernet Connection

COMMUNICATION INTERFACE
141
Configure Ethernet Connection
The Ethernet interface can be configured for a number of different
applications. Ethernet can be configured for basic remote control or
monitoring using a web server or it can be configured as a socket
server.
The PSW series supports both DHCP connections so the instrument
can be automatically connected to an existing network or
alternatively, network settings can be manually configured.
Ethernet
configuration
Parameters
For details on how to configure the Ethernet
settings, please see the configuration chapter on
page 107.
MAC Address
(display only)
LAN
DHCP
IP Address
Subnet Mask
Gateway
DNS Address
Sockets Active
Web Server Active
Web Password Active
Web set password
0000~9999 (default 0000)
Web Server Configuration
Configuration
This configuration example will configure the
PSW as a web server and use DHCP to
automatically assign an IP address to the PSW.
1. Connect an Ethernet cable from the
network to the rear panel Ethernet
port.
LAN