GW Instek PSW Series - Page 52

PSW Series User Manual
52
1. Repeatedly press the Voltage knob
until the last digit is highlighted.
This will allow the voltage to be
edited in 0.01 volt steps.
2. Turn the Voltage knob till 0.05
volts is shown.
Voltage
Voltage
V
A
→
V
A
3. Repeatedly press the Voltage knob until the
first digit is highlighted. This will allow the
voltage to be edited in 1 volt steps.
4. Turn the Voltage knob until 10.05 is shown.
V
A
→
V
A
Note
Notice the Set key becomes illuminated when
setting the current or voltage.
If the Voltage or Current knobs are unresponsive,
press the Set key first.