H3C S3100V2-52TP

88
Task Remarks
Using the remote probe VLAN to enable local mirroring to support
multiple monitor ports
Optional
Creating a local mirroring group
Follow these steps to create a local mirroring group:
To do… Use the command… Remarks
Enter system view system-view —
Create a local mirroring group mirroring-group group-id local
Required
No local mirroring group
exists by default.
NOTE:
A local mirroring group takes effect only after you configure a monitor port and source ports/CPUs for it.
Configuring source ports for the local mirroring group
If you use system view, you can use a list to configure multiple source ports for a mirroring group at one
time. If you use interface view, you can assign only the current port to the group as a source port, so you
must repeat the step for each additional port.
Configuring source ports in system view
Follow these steps to configure source ports for a local mirroring group in system view:
To do… Use the command… Remarks
Enter system view system-view —
Configure source ports
mirroring-group group-id
mirroring-port mirroring-port-list
{ both | inbound | outbound }
Required
By default, no source port is configured
for a local mirroring group.
Configuring a source port in interface view
Follow these steps to configure a source port for a local mirroring group in interface view:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Configure the current port
as a source port
[ mirroring-group group-id ]
mirroring-port { both | inbound |
outbound }
Required
By default, a port does not serve as a
source port for any local mirroring group.