130
To do… Use the command… Remarks
Configure the size of the
data field in each probe
packet
data-size size
Optional
By default, the probe packet size depends on the
codec type. The default packet size is 172 bytes for
G.711A-law and G.711 μ-law codec type, and 32
bytes for G.729 A-law codec type.
Configure the string to be
filled in the data field of
each probe packet
data-fill string
Optional
By default, the string is the hexadecimal number
00010203040506070809.
Configure the number of
probe packets to be sent
during each voice probe
operation
probe packet-number
packet-number
Optional
1000 by default.
Configure the interval for
sending probe packets
during each voice probe
operation
probe packet-interval
packet-interval
Optional
20 milliseconds by default.
Configure the interval the
NQA client must wait for
a response from the
server before it regards
the response times out
probe packet-timeout
packet-timeout
Optional
5000 milliseconds by default.
Configure optional
parameters
See “Configuring optional
parameters for an NQA
test group”
Optional
NOTE:
Only one probe operation is performed in one voice test.
Configuring DLSw tests
DLSw tests of an NQA test group are used to test the response time of a DLSw device.
Configuration prerequisites
Before you start DLSw tests, enable the DLSw function on the peer device.
Configuring a DLSw test
Follow these steps to configure DLSw tests:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as
DLSw, and enter test type
view
type dlsw Required
To Next Page
Loading...
