181
To do… Use the command… Remarks
Enter cluster view cluster —
Configure the SNMP community
name shared by a cluster
cluster-snmp-agent community
{ read | write } community-name
[ mib-view view-name ]
Required
Configure the SNMPv3 group
shared by a cluster
cluster-snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view read-view ]
[ write-view write-view ]
[ notify-view notify-view ]
Required
Create or update information of
the MIB view shared by a cluster
cluster-snmp-agent mib-view
included view-name oid-tree
Required
By default, the name of the MIB
view shared by a cluster is
ViewDefault and a cluster can
access the ISO subtree.
Add a user for the SNMPv3 group
shared by a cluster
cluster-snmp-agent usm-user v3
user-name group-name
[ authentication-mode { md5 |
sha } auth-password ]
[ privacy-mode des56
priv-password ]
Required
NOTE:
• The SNMP-related configurations are retained when a cluster is dismissed or the member switches
are
removed from the whitelist.
• For more information about SNMP, see the chapter “SNMP configuration.”
Configuring web user accounts in batches
Configuring web user accounts in batches enables you to do the following:
• Through the web interface, configure, on the management switch, the username and password
used to log in to the cluster switches (including the management switch and member switches) .
• Synchronize the configurations to the member switches in the whitelist.
This operation is equal to performing the configurations on the member switches. You need to enter your
username and password when you log in to the cluster switches (including the management switch and
member switches) through the web interface.
Follow these steps to configure web user accounts in batches:
To do… Use the command… Remarks
Enter system view system-view —
Enter cluster view cluster —
Configure web user accounts in
batches
cluster-local-user user-name password { cipher |
simple } password
Required
To Next Page
Loading...
Need help?
General
