H3C S3100V2-52TP

176
To do… Use the command… Remarks
Configure the destination
MAC address for cluster
management protocol
packets
cluster-mac mac-address
Required
The destination MAC address is
0180-C200-000A by default.
The following are the configurable MAC
addresses:
• 0180-C200-0000
• 0180-C200-000A
• 0180-C200-0020 through
0180-C200-002F
• 010F-E200-0002
Configure the interval to send
MAC address negotiation
broadcast packets
cluster-mac syn-interval
interval
Optional
One minute by default.
CAUTION:
When you configure the destination MAC address for cluster management protocol packets:
• If the interval for sending MAC address negotiation broadcast packets
is 0, the system automatically sets
it to 1 minute.
• If the interval for sending MAC address negotiation broadcast packets is not 0, the interval remains
unchanged.
Cluster member management
You can manually add a candidate switch to a cluster, or remove a member switch from a cluster.
If a member switch needs to be rebooted for software upgrade or configuration update, you can
remotely reboot it through the management switch.
Adding a member switch
To do… Use the command… Remarks
Enter system view system-view —
Enter cluster view cluster —
Add a candidate switch to the
cluster
add-member [ member-number ] mac-address
mac-address [ password password ]
Required
Removing a member switch
To do… Use the command… Remarks
Enter system view system-view —
Enter cluster view cluster —
Remove a member switch from the
cluster
delete-member member-number
[ to-black-list ]
Required