155
3. On Device A, create an NQA test group.
# Create an NQA test group with the administrator name being admin and operation tag being test.
[DeviceA] nqa entry admin test
# Configure the test type of the NQA test group as ICMP echo.
[DeviceA-nqa-admin-test] type icmp-echo
# Configure ICMP echo requests to use 10.2.1.1 as their destination IP address.
[DeviceA-nqa-admin-test-icmp-echo] destination ip 10.2.1.1
# Configure the device to perform tests at an interval of 100 milliseconds.
[DeviceA-nqa-admin-test-icmp-echo] frequency 100
# Create reaction entry 1. If the number of consecutive probe failures reaches 5, collaboration with other
modules is triggered.
[DeviceA-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail threshold-type
consecutive 5 action-type trigger-only
[DeviceA-nqa-admin-test-icmp-echo] quit
# Configure the test start time and test duration for the test group.
[DeviceA] nqa schedule admin test start-time now lifetime forever
4. On Device A, create the track entry.
# Create track entry 1, and associate it with reaction entry 1 of the NQA test group (admin-test).
[DeviceA] track 1 nqa entry admin test reaction 1
5. Verify the configuration.
# On Device A, display information about all the track entries.
[DeviceA] display track all
Track ID: 1
Status: Positive
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
NQA entry: admin test
Reaction: 1
# Display brief information about active routes in the routing table on Device A.
[DeviceA] display ip routing-table
Routing Tables: Public
Destinations : 5 Routes : 5
Destination/Mask Proto Pre Cost NextHop Interface
10.1.1.0/24 Static 60 0 10.2.1.1 Vlan3
10.2.1.0/24 Direct 0 0 10.2.1.2 Vlan3
10.2.1.2/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
The output shows that the static route with the next hop 10.2.1.1 is active, and the status of the track entry
is positive. The static route configuration works.
# Remove the IP address of VLAN-interface 3 on Device B.
<DeviceB> system-view
To Next Page
Loading...
