HANROAD TREK4 - Hot Water Pack Option (Water Heater); Shower Head

126
7000056136-0
EN
5.9.6 - Hot water pack option (water heater)
I
III
II
0
F
1
3
2
1 Water heater
2 Thermostat
3 Pushbutton
The water heater installed under the rear bench provides six litres of hot water.
To set the water temperature:
■ Tilt the seat of the rear bench.
■ Turn the thermostat (2) to obtain the desired setting.
There are four possible positions:
– Position 1: 35 °C.
– Position 2: 50 °C.
– Position 3: 80 °C.
– Position F: frost protection.
Beware of the risk of scalds if the water is too hot.
A three-minute exposure to water heated to 51° can lead to a deep
burn in the skin.
To switch on the water heater:
■ Press the pushbutton (3).
The water heater operates for 60 minutes.
Aer 60 minutes of operation, the water heater switches o automatically.
To obtain hotter water, press the button again to run a second heating
cycle.
The water heater consumes a lot of energy. Charge the battery aer
each use.
5.9.7 - Shower head
2
4
1
3
1 Quick tting
2 Water temperature mixer
3 Shower head
4 Lever
The shower head is stowed in the cupboard located above the gas cylinder.
The shower is connected to the water supply at the rear of the vehicle.
To use the shower:
■ Push the shower tting into the quick tting (1).
■ Press the lever (4) of the shower to run the water.
■ Use the mixer (2) to adjust the water temperature (available with the hot
water option).