HANROAD TREK4 - Waste Water Tank Full Alarm; Gas Supply; Opening the Gas Inlet

127
7000056136-0
EN
To disconnect the shower:
■ Push the ring of the quick tting (1).
■ Remove the shower tting from the quick tting.
■ Empty the shower head by pressing the lever (4).
■ Use a dry cloth to wipe o the remaining drops of water.
■ Stow the shower head in the cupboard.
Stow the hose in a way that prevents any water remaining in it from
leaking out into the vehicle.
5.9.8 - Waste water tank full alarm
5
25
ext.
T
1
1 "Waste water tank full" indicator
This alarm appears when the waste water tank is full.
The alarm is indicated by:
– The ashing of the "Waste water tank full" indicator.
– A sound (only when the engine is o).
This alarm disappears aer the waste water tank is emptied (see page 140).
5.10 - Gas supply
5.10.1 - Opening the gas inlet
1
2
1 Gas cylinder access door
2 Stopcock
OFF
ON
3 3
3 Gas stopcock
■ Open the gas cylinder access door (1) (See page 90).
■ Turn the gas stopcock (2) anticlockwise.
The gas stopcock (3) is installed in the cupboard under the stove.
To open the gas stove gas inlet:
■ Turn the gas stopcock (3) clockwise.
Visual check: when the axis of the gas stopcock (3) is parallel to the axis
of the pipe, gas is supplied to the stove.