HANROAD TREK4 - Waste Water Drain Spout; Pop-Up Roof Canvas; Wintering; Draining the Fresh Water and Waste Water Circuits

140
7000056136-0
EN
7.10 - Waste water drain spout
Storm drains (gutters) cannot be used for drainage, because those
systems do not all include a purication treatment. Only empty the
waste water tank at locations intended for that purpose, such as:
– Dump stations.
– Campsites.
– Service areas.
– Municipal facilities.
The waste water tank is installed under the vehicle.
OFF
ON
1
1
1 Drain valve
The drain valve (1) is located under the vehicle, on the le-hand side.
An alarm is displayed on the instrumentation and control panel when the waste
water tank is full (see page 127).
To drain the waste water tank:
■ Turn the drain valve (1) anticlockwise to open it.
Aer draining:
■ Turn the drain valve (1) clockwise to close it.
Check that the drain valve is properly closed.
7.11 - Pop-up roof canvas
■ Waterproof the canvas using an appropriate waterproong product for the
textile.
8 - Wintering
8.1 - Draining the fresh water and waste water
circuits
In case of freezing weather, when storing the vehicle for a long time, the fresh
water circuit and the waste water circuit must be completely drained.
■ In the sink, open the tap to a middle position.
■ Open the drain valves to a middle position.
This recommendation allows air to ow through the water circuit, which limits
the risk of freezing and stagnant water in the circuits and components.
8.2 - Water heater
The fresh water circuit must be emptied.
I
III
II
0
F
1
2
1 Water heater
2 Thermostat
The water heater is installed under the rear bench.
■ Tilt the seat of the rear bench.
■ Turn the thermostat (2) to position F (frost protection).