Harris FR6822+ - User Manual

Questions and Answers

S
Shari CharlesAug 2, 2025
What to do if CSCC application cannot control Harris 6800+ETH Network Router module?
- P
  Patrick PageAug 2, 2025
  If the CSCC application is unable to control the Harris 6800+ETH Network Router module, verify the module is correctly seated in its frame slot. Also, confirm that the CCS application's status bar indicates the module is ready, and that you have the necessary access rights to control the module and its parameters. Finally, ensure that no ICE6800+ modules are installed in the same frame as the 6800+ETH module.
M
Ms. Jennifer Young PhDAug 10, 2025
Why can't I discover some or all Harris 6800+ Network Router devices?
- M
  Melissa MunozAug 11, 2025
  If you cannot discover some or all Harris 6800+ Network Router devices, make sure your PC is a single processor. Check that the IP address settings for both your PC and the 6800+ETH module are on the same subnet. Ensure the FR6822+QXFE frame is turned on last and allowed 3-4 minutes to initialize. Confirm all front and back modules are securely plugged in and seated correctly, that front modules match their corresponding back connectors, and that all 6800 series modules are compatible.
M
Michael BarrAug 18, 2025
What to do if Harris FR6822+ Network Router hardware fails to communicate with PC after power failure?
- A
  Amber WatsonAug 18, 2025
  If the Harris Network Router hardware fails to communicate with your PC after a power failure, allow the frame at least three minutes to recover before exiting the application and logging back in.
E
Emma MarquezAug 25, 2025
How to fix Ethernet Network or FR6822+QXFE Frame Failure on Harris FR6822+?
- B
  Becky AllenAug 25, 2025
  In the event of an Ethernet Network or FR6822+QXFE Frame Failure with your Harris Network Router, first ensure the 6800+ETH module is connected using the correct Ethernet cable. Additionally, verify that the coaxial loop is properly terminated with a 75? BNC terminator on all connected frames.