FR6822+ Frames
Installation and Operation Manual
59
Copyright © 2008-2011, Harris Corporation
If the upgrade fails, remove and then reapply power to the FR6822+ QXFE host frame. After
a failed upgrade, the module should automatically go into a Boot Loader mode where new
software can be loaded but other functions are not enabled. You may now try the upgrade
procedure again.
See Telnet Commands on page 70 for more information.
Activating a 6800+ETH License Using an HTTP Browser
For information on licenses available for the 6800+ETH module, see Choosing 6800+ETH
Upgrade Options on page 10. To obtain a license, contact Customer Service. You will
need the module’s serial number.
To activate a license key using the 6800+ HTTP control interface, follow these steps:
1 In your browser, enter the IP address of the 6800+ETH module, and then click Enter to
connect.
The 6800+ Control Interface appears.
If the 6800+ETH module is off or in a failed state (i.e., disconnected), you will see a “file not
found” message.
2 Type a user name and password if required, and then click Enter.
3 In the navigation pane, select Slot 21 - 6800+ETH > Configuration > Device.
4 Enter your device key in the License Key field, and then click Write and Reboot.
You are now ready to configure the options you have unlocked.
Note: You can also activate 6800+ETH license keys using CCS Navigator. See Activating a
6800+ETH License in CCS Software on page 43.
Discovering HTTP Devices in CCS Navigator
If you discover your 6800+ETH as an HTTP device, you can launch a web browser from
within the Navigation pane for control and monitoring purposes. Follow these steps:
1 From the main menu, choose Options > Discovery.
The Discovery Options dialog box appears.
To Next Page
Loading...