FR6822+ Frames
Installation and Operation Manual
61
Copyright © 2008-2011, Harris Corporation
When a 6800+ETH module has optional SNMP, you can monitor the host frame using a
third-party SNMP-based control application such as NuDesign’s Visual MIBrowser
®
Pro.
You can configure your 6800+ETH for monitoring and control via SNMP using the following
tools:
HTTP control interface: You must be logged on as an administrator user. See
Configuring SNMP Settings Using HTTP on page 61.
CCS Navigator: You must have control and configuration access rights in CCS Navigator
(access rights for control and configuration can be set by someone in the Pilot, CoPilot,
or Navigator Admin groups). See Configuring SNMP Agent and System Settings on
page 64.
Once SNMP is configured, you can further configure your SNMP software to receive
6800+ETH data. See Configuring Third-Party SNMP Software Control on page 66.
To monitor and control your frame and modules using SNMP, see Monitoring and Control
Using MIBs on page 68.
Configuring SNMP Settings Using HTTP
You can configure SNMP settings using the free HTTP browser functionality of your
6800+ETH module. To connect to the frame and modules using a standard web browser,
see Logging In To 6800+ HTTP Control Interface on page 44.
1 Click Administrator > SNMP (in either the Navigation pane or the control pane).
The control pane displays the following:
To Next Page
Loading...