Harris FR6822+ - Telnet Commands

Chapter 4
FR6822+QXFE Configuration, Monitoring, and Control
70
Copyright © 2008-2011, Harris Corporation
Legend
Bold option=Indicates that this is the default setting for the parameter.
Note: The 6800+ETH module has no alarms.
Telnet
Commands
Before you can send Telnet commands to your 6800+ETH module, you must establish a
Telnet session. See Establishing a Telnet Session on page 70.
The Telnet commands for the 6800+ETH include the following:
 getipaddr on page 71
 getmacaddr on page 71
 setipaddr on page 72
 reboot on page 72
Establishing a Telnet Session
From a PC command prompt, input the following command to establish a Telnet session to
the 6800+ETH module if the Telnet application is resident on the PC:
C:\telnet 192.168.100.250
(Where 192.168.100.250 is the IP address of the 6800+ETH module)
Note: 192.168.100.250 is the default IP address for the 6800+ETH module.
To establish a Telnet session to the 6800+ETH resource module, use the following user
name and password:
Table 4-7 Remote Control Parameter Options on 6800+ETH
Parameter
Name
Function Options
IP Address Specifies the module’s
IP address
String (Default:
192.168.100.250)
ThumbRate Determines the refresh
rate of the thumbnail
on this Control dialog
box
 3 frame/sec
 2 frame/sec
 1 frame/sec
 1 frame/2 sec
 1 frame/3 sec
 1 frame/4 sec
 1 frame/5 sec
 1 frame/6 sec
 1 frame/7 sec
 1 frame/8 sec
 1 frame/9 sec
 1 frame/10 sec