Chapter 4
FR6822+QXFE Configuration, Monitoring, and Control
44
Copyright © 2008-2011, Harris Corporation
Using an HTTP Browser with FR6822+QXFE
The 6800+ETH provides HTTP control and monitoring for 6800+ frames and modules.
A generic HTTP control interface allows up to 20 simultaneous monitoring connections.
Each connection shows device alarm and parameter information. When a change occurs to
a device, such as an alarm or a parameter change, that change may take 3–5 seconds to
appear on the monitoring screens of other users monitoring via HTTP server.
The HTTP control and monitoring interface also supports sub-devices, such as inputs to a
QSEE6800+ module.
For more information see the following topics:
System Requirements for Device Monitoring Using HTTP on page 44
Logging In To 6800+ HTTP Control Interface on page 44
Managing User Accounts on page 46
Logging Off from 6800+ HTTP Control Interface on page 49
Control and Monitoring 6800+ Modules and Frames over HTTP on page 49
Streaming Video on page 52
Using Presets With 6800+ETH on page 55
Upgrading Module Firmware Using an HTTP Browser on page 57
Discovering HTTP Devices in CCS Navigator on page 59
Configuring SNMP Settings Using HTTP on page 61
System Requirements for Device Monitoring Using HTTP
To monitor and control devices using a web browser, ensure you have the following:
6800+ETH firmware version 3.0 or higher
This document describes functionality as of firmware version 4.2. To obtain a firmware
upgrade, go to our website. For information on upgrading a 6800+ETH module’s
firmware, see Upgrading Module Firmware Using an HTTP Browser on page 57.
A PC connected to a LAN with a JavaScript enabled web browser such as Microsoft
Internet Explorer 6.0
A FR6822+ frame installed and connected to the LAN
A standard 100 Mbps 100Base-T RJ-45 Ethernet cable segment (use a “crossover”
RJ-45 cable to connect to a PC, or a normal “straight-through” RJ-45 cable to connect
to an Ethernet hub/switch)
Logging In To 6800+ HTTP Control Interface
To open a browser connection to a 6800+ frame, follow these steps:
1 In your browser, enter the IP address of the 6800+ETH module and click Enter to connect.
To Next Page
Loading...