Hatteras HN4000 User Manual

Grounding D-3
920550-5020 Rev 14 HN4000 Hardware Installation Guide
D.6 Grounding
1. Theprotective‐earthgroundwireshouldbe10‐14AWG.
2. Yourlocalelectricalcodemayrequirethataspecificcolor(orcolors)beusedforthe
protective‐earthgroundwire.
D.7 Laser and Fiber Optic
TheHN4000isaClass1laserdevice.
Caution
The HN4000mustbepermanentlygroundedtoaCommonBondingNetwork(CBN).
Fiber Optic ports - Optical Safety. Never look at the transmit LED/laser through a magnifying
device while it is powered on. Never look directly at the fiber port or fiber cable ends when they are
powered on.
Caution
To avoid degradation of optical-fiber signals and poor system performance, follow appropriate
local practices to ensure that optical-fiber connector ends are clean and free from contamination.
Always install the provided dust covers on transceiver optical ports and connector ends that are
not being used.
Caution
Use only for data communications applications that require optical fiber. Use only with the appro-
priate connector. When optical fiber cables are not in use, replace the dust cover.

Hatteras HN4000 Specifications

General

Brand	Hatteras
Model	HN4000
Category	Switch
Language	English