HDG Lambda-Control 1 plus - Type of Wood - Moisture - Change Refuel Amount; Operation Display: Boiler ON; Boiler off

21
3.6 Type of wood – Moisture – Change refuel amount
● Cancel power saving function by pressing any button.
● Press button ► to activate the refuel program.
● Follow the instructions displayed.
● After the safety program for “Open door(s)” is completed, “Refuel” is displayed.
Refuel 90%: The chamber can be filled up to 90% with copper birch.
Example for “Refuel 120%”: Theoretically required fuel amount to load the accumulator to capacity
with one combustion.
Change type of wood:
● Press ◄, the bar changes to “Wood”, use buttons▲/▼ to select type of wood.
● Press button ◄ to confirm the set type of wood.
Change moisture level:
● Select moisture level using buttons ▲/▼, press ◄, the bar changes to “Moisture”.
● Use buttons ▲/▼, select “low” – “medium” – “high”, see chapter 1.19.
● Press button ◄ to confirm the set moisture level.
Change refuel amount (only displayed with BSB):
● Proceed as described under “Change moisture level” to change the “Refuel amount”.
● The refuel amount may be reduced, if a smaller amount is refuelled; this is important for
calculating the heating date after closing the door(s). The refuel amount may be reduced to
the minimum amount required for AFO (chapter 1.4).
3.7 Operation display: “Boiler ON” / “Boiler OFF”
The content depends on the installed sensors – F1 / F4 / BSB-F5(1-4).
Contents of screen
In case of an error, the screen changes every 15 seconds to an error display.
Example: screen 5.
Refuel 90%
Wood Copper birch
Moisture medium
Refuel amount 90%
Refuel 120%
Wood Spruce
Moisture medium
Refuel amount 100%
Refuel 90%
Wood Copper birch
Moisture medium
Refuel amount 90%
Date Time
Boiler ON
Boiler temp. ---.-°C
…
…
Acc. load
AFO …
Position display in menus, if they contain more than displayed.
Bar diagram of accumulator load with BSB.
Bar diagram empty, when “Acc. t.-F4” is ≤ 9.03 Refuel signal (= 0 kWh accumulator load).
Bar diagram full, when accumulator load is ≥ 75%.
Shows currently working or selected functions.
Displays important information/errors or settings.
Current operating data
Date Time
Outside temp. ---.-°C
Boiler temp. ---.-°C
Boiler OFF appr. dd hh:mm
Heating date dd hh:mm
Refuel amount ---%
Acc. load
Date Time
Outside temp. ---.-°C
Boiler temp. ---.-°C
Heating date dd hh:mm
Refuel amount ---%
Acc. t.-F4 ---.-°C
Acc. load