2.5 Changes to system settings
Pressing the ◄ button for approx. 5 sec brings you directly to the language selection menu, where
the language can be changed.
The Technician password is required for changes to the system settings. After commissioning it is
set in “Selection” → “Password” (see chapter 2.3). Use button ► to switch from submenu
“Password” to menu “Selection”. The menu “Selection” contains the submenu “System”, after
selecting and confirming it with ◄, the necessary changes or control can be made.
All settings in menus that require passwords are enabled for 12 hours after entering the password.
To lock them earlier, confirm the generated number in “Selection” → “Password” without changes
with ◄ (note: “No password” in text display).
Check notes for settings in chapter 2.4, which are the following:
10.01 Language English EN
10.02 Heating sys. No. ---
10.03 B-Type ---
10.04 Boiler new YES
10.05 Y1 Rotary valve
10.06 Outside sensor NO
10.07 Outside sensor No. 1
10.08 Acc. sensor F4 YES
10.09 Acc. sensor No. 1
10.10 BSB-F5(1-4) NO
10.11 Bus No. 1
10.12 Note 26.33 NO
10.13 Note 26.34 NO
20.00 Pellet/Oil/Gas NO
30.48 Ext.-1 HC NO
30.50 Ext.-ignition NO
To Next Page
Loading...