7 DCF77- Receiver
Only displayed if a DCF77-Receiver is installed.
Depending on the region it can happen that a receiving a DCF signal is not possible.
The menu “DCF77-Receiver” is located in the “Selection” menu. It is a radio receiver for automatic synchronization of
date and time. The submenus of the “DCF77-Receiver” menu are described below.
7.1 Information
Status: Possible displays: “not synchronized” / “synchronized” = Date and time set.
Reception: Reception control. If the bars fill up entirely within seconds, the reception is good.
sync. on: Date of the last synchronization.
7.2 Settings
15.01 DCF77-Receiver NO
Possible settings: “YES” / “NO”.
NO: DCF77-Receiver is not installed; or if it is defective and Error 26.25: DCF77-Receiver no reception
should not be displayed.
15.02 Time zone GMT+1 Setting range -1 – +3
+1: Setting for AT, DE, IT, FR, DK, SE and other countries in this time zone.
Note: If the reception is not sufficient, the date and time must be set manually. Reception is usually best
at night. The receiver is always activated so that the new time is displayed fairly quickly
(depending on the reception) when changing to/from summer time.
To Next Page
Loading...