HDG Lambda-Control 1 plus - Operations Counter

23
O
2
--.-%
Actual value of oxygen in flue gas. (current value)
CO
2
--.-%
Actual value of carbon monoxide in flue gas. (current value)
Lambda (λ) --.--
Air ratio. (current value)
Efficiency ---.-%
Fire efficiency degree. (current value)
Difference KV-KR --.-K
Difference between boiler flow temperature and boiler return temperature. (current value)
Flue gas max. ---.-°C
Maximum flue gas temperature.
*) Boiler OFF ca. TT --:--
Estimated end of burning cycle, day – hour : minute.
*) Heating date TT --:--
Displays the estimated date and time of the next heating, day – hour : minute.
*) Refuel amount ---%
Display set in %: Fill chamber to “%” (measured in height).
Display set in kg: Refuel “kg” only.
*
)
Display only with (Fuel calculation function)
4.1.2 Operations counter
Selection
Wood Boiler
Wood Boiler
…
Information
Information
Settings
Operating data
Chimney sweep
Operations counter
Operations counter
Calibrate O
2
*
Aggregates
Overtemp. total --.-%
Aggregate test*
Commissioning
Overt. 10 b/c --.-%
Last error
Boiler t. --------.-h
Last note
Boiler p. --------.-h
Delete values
QK total --------.-kWh
QK period --------.-kWh
Service s. in** ---.-h
Service in ---.-h
O
2
cal. before ---.- h
Contr. ----.-h
Delete periods NO
YES
Only displayed with Manufacturer-password
Delete total NO
YES
Only displayed with Technician-password
Del. Service large NO
YES
◄ Call up Selection menu
▲▼ Select Wood Boiler
◄ Confirm selection
► Leave menu
▲▼ Select Information
◄ Confirm selection
► Leave menu
▲▼ Select Operations
counter
◄ Confirm selection
► Leave menu
▲▼ Browse menu
► Leave menu
▲▼ Select Delete periods /
(total) / (Service large)
◄ Confirm selection
▲▼ Select YES
◄ Confirm selection
► Leave menu
*only displayed in operating status “Boiler OFF“ **only displayed if the setting in 5.23 Service small is “YES”
Overtemp. total --.-%
Overtemperature total.
Boiler temperature higher than 90°C = flue gas fan OFF
Use: The user can optimise his refuelling habits.
Delete: At > 10%: high boiler wear and tear – emissions, environmental issues.
Calculation: A total of x% of operating hours were with overtemperature.