HDG Lambda-Control 1 plus - Function Display; Example of Application - Boiler Exchange

84 pages

Save Page as PDF

To Next Page

To Previous Page

1.2 Function display

AAO Combustion and Burnout Optimisation ABO Combustion Demand Optimisation

AFO Fire Optimisation Frost Anti-freeze activated

KLA Reduced Boiler Output Öl-Gas Pellet/Oil/Gas operation mode enabled

PAE Accumulator Run-up Easing RSA Rapid System Heating

RWO Residual Heat Optimisation SLA Peak Load Coverage

1.3 Example of application – boiler exchange

Main Page

Index2
- Table of Contents2
Introduction5
- Abbreviations and Technical Terms5
- Display and Control Elements6
- Function Display7
- Example of Application - Boiler Exchange7
- AFO: Fire Optimisation8
- KLA: Reduced Boiler Output8
- AAO: Combustion and Burnout Optimisation8
- RSA: Rapid System Heating9
- SLA: Peak Load Coverage9
- PAE: Accumulator Run-Up Easing9
- Residual Heat Use10
- RWO: Residual Heat Optimisation10
- BSB: Basic Principles11
- BSB: Fuel Calculation Without Heating Demand11
- BSB: Fuel Calculation with Heating Demand11
- BSB: ABO - Burning Demand Optimisation11
- Minimum Flue Gas Temperature12
- Refuel Signal12
- Integrated Fuel Types13
- Water Content - Moisture of the Fuel14
- Refuel Amount14
- Energy Content and Usable Energy Content of the Fuel14
- Protective Functions for the Boiler/ Pumps - Valve Stuck Protection15
Commissioning16
- Safety Instructions for the System Commissioning16
- Minimum Requirements for a Trial Run and Heating Test16
- Technician Password17
- Commissioning Settings17
- Changes to System Settings19
Important Notes for Heating20
- Opening Door(S) and Firing20
- Refuelling in Operating Status "Boiler on20
- Flue Gas Temperature too High20
- Safety Shutdown20
- Service Program: "Service Small" and "Service Large21
- Type of Wood - Moisture - Change Refuel Amount22
- Operation Display: "Boiler ON" / "Boiler off22
Wood Boiler23
- Information23
- Settings29
- Chimney Sweep Test34
  - Example: Select Chimney Sweep: Rated Power35
- Calibrate O Sensor35
  - Manual Calibration35
  - Automatic Calibration35
- Aggregate Test36
Accumulator38
- Logotherm Conform Sensor Positioning39
- Information40
- Settings40
Date and Time41
DCF77- Receiver42
- Information42
- Settings42
Pellet/Oil/Gas Boiler43
- Pellet/Oil/Gas Boiler - Heating System 2.043
  - Operation Mode44
  - Settings44
- Pellet/Oil/Gas Boiler - Heating System 2.145
System Operation Mode49
- Operation Mode49
- Holiday49
- Summer Operation50
Errors - Notes51
- Note 1.16: Protective Functions51
- Error 1.17: EW-1 HC BUS-Communication51
- Error 1.18: EW-Ignition BUS-Communication51
- Error 2.30: Ignition Failed52
- Error 2.31: Ignition Error52
- Error 26.01: Memory Error (EE-Prom)52
- Error 26.02: Program Surveillance (Watchdog)52
- Error 26.03: Voltage Reference52
- Error 26.04: Base Point Control53
- Error 26.05: ADC (Analogue/Digital Converter)53
- Error 26.06: Sensor Not Connected53
- Error 26.07: Water Shortage Fuse Activated54
- Error 26.08: STB Triggered54
- Error 26.09: Boiler Sensor55
- Error 26.10: Actuator V155
- Error 26.11: Actuator V255
- Error 26.13: O 2 Sensor56
- Error 26.14: O 2 Sensor56
- Error 26.15: O 2 Sensor57
- Error 26.17: O 2 Sensor57
- Error 26.18: O 2 Sensor58
- Error 26.19: O 2 Sensor58
- Note 26.21: Overtemperature59
- Error 26.22: Flue Gas Sensor59
- Error 26.23: Return Sensor60
- Error 26.24: Date - Time Not Set60
- Error 26.25: DCF77-Receiver no Reception60
- Error 26.26: Outside Sensor61
- Note 26.27: Flow Rate too Low61
- Error 26.28: Return Temperature too Low61
- Note 26.29: Flue Gas Temperature too High62
- Note 26.30: Small Service Required62
- Note 26.31: Large Service Required62
- Note 26.32: System Overload62
- Note 26.33: Fuel too Large or too Wet63
- Note 26.34: Fuel too Small or too Dry63
- Error 26.35: Accumulator Sensor F463
- Error 26.37: BSB-F5(1-4)64
- Note 26.38: Boiler Manual off64
- Note 26.47: Pellet/Oil/Gas Boiler - Residual Heat Use64
- Error 26.53: Outside Sensor from BUS64
- Error 26.54: Accumulator Sensor F4 from BUS64
- Error 26.55: BSB F5(1 - 4) from BUS65
11 TÜV: Tests and Engineering Standards65
12 TÜV: Notes about Safety Functions66
- Flush Chimney after Power Failure66
- Open Door(S) in Operating Status "Boiler on66
- Open Door(S) in Operating Status "Boiler off66
- Pellet/Oil/Gas Enabling66
Tips and Recommendations67
- System Overload (Note 26.32)67
- Calculating the Loading Capacity of the Accumulator67
- Use of the WA3 for an Electric Heating Application67
Tips for the Electrical Connection68
Installation68
Plug Board69
Lambda-Control 1 - Plug Board: Connection Plan70
Establishing the Electrical Connection71
Technical Data72
Electrical Connection - Boiler73
- ST1: O 2 -Sensor73
- ST2: Flue Gas Sensor AGF1500/ Pt10073
- ST3: Boiler- and STB-Sensor (KF+STB2000)73
- ST5: Boiler-Return Sensor F3 Pt200073
- ST11: Door Release74
- ST12: Primary Air Actuator (V1)74
- ST13: Secondary Air Actuator (V2)74
- ST14: Differential Pressure Switch (Vacuum Actuator)74
- ST15: Load Pump M175
- ST16: Flue Gas Fan (1-Level)75
- ST16: Flue Gas Fan (2-Level)75
- ST21: Capacitor C1 (Optional for Cleaning)75
- ST25: Power Supply 230V75
Electrical Connection - Options (Depending on the System)76
- ST4: Outside Sensor and DCF77-Receiver (AF2000/DCF77)76
- ST4: Outside Sensor Pt2000 (AF2000)76
- ST6: WAE2 Optional Output for Remote Indication (LED)76
- ST8: Accumulator Sensor (F4) und Fuel Calculation (BSB) F5-1 - F5-4 (1-Wire Termination)76
- ST8: Accumulator Sensor (F4) und Fuel Calculation (BSB) F5-1 - F5-4 (2-Wire Termination)77
- ST9: Water Shortage Fuse (WMS)77
- ST22: Optional Output 3 (WA3): Oil/Gas Boiler (Integrated in Safety Chain)77
- ST22: Optional Output 3 (WA3): Oil/Gas Boiler (Not Integrated in Safety Chain)77
- ST22: Optional Output 3 (WA3): Activation of External Pellet/Oil/Gas Boiler78
- ST22: Optional Output 3 (WA3): Activation of Electric Heating Element78
- ST23: Optional Output 4 (WA4): Load-/ Unload Valve Y278
- ST24: Option Output 5 (WA5): Return Valve Y178
Legend and Special Notes79
Hydraulic System 2.080
Hydraulic System 2.181
Subject Index82

HDG Lambda-Control 1 plus - Function Display; Example of Application - Boiler Exchange

Table of Contents