3. Configuring the Heska Element COAG
™
Analyzer
3.2.5.2. Set Time
The screen for setting or displaying the current time is shown in Figure 3.9.
Figure 3.9: Time menu.
The current time is dis-
played in the text field
at the top of the page.
To change the current
time use the on-screen
keyboard. The time
must be specified
using the format shown
below the entry field.
When the complete
entry complies with this
format, Correct Format
is displayed above the
text field. Otherwise,
Incorrect Format is
displayed.
To set the current time:
1. From the Home Screen, touch Setup (this opens the Settings Menu).
2.
From the Settings Menu, touch to the right of the Regional Setup category (this
opens the Regional Setup Menu).
3.
From the Regional Setup page, touch to the right of the Time entry field.
Figure 3.9 shows the Set Time screen.
4. Use the on-screen keyboard to enter the time.
5. Confirm by touching Done.
i
The Time Format is shown below the Entry Box. Incorrect Format message is
displayed above the entry box until the complete entry has been made. When
the entry has been completed with the correct format, Correct Format message
is displayed. The time and date format can be changed in the US/Europe Menu,
see Section 3.2.5.3.
i
Touching
Cancel
clears any undesired change(s) and touching
Done
confirms
the change(s).
22
To Next Page
Loading...
