Hioki 3227 - Page 100

88
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Synta
x
:COMParator?
Functio
n
･ Returns the presently using comparator table in the range 0 to 15 (data).
･ The setting state becomes followingly.
･ When "data = 0", the comparator becomes OFF.
･ When "data = 1 to 15", the presently using comparator number is shown.
Respons
e
If headers are ON
If headers are OFF
:COMPARATOR data
data
Erro
r
The execution error is generated, when the measurement mode is set to the
temperature measurement.
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:COMP?
:COMPARATOR 1
:COMP?
1
Synta
x
:CSET:BEEPer data
dat
a
OFF, HL, IN (character data)
Functio
n
Sets the buzzer mode of the comparator table set by ":CSET:TABLe"
command.
Exampl
e
Transmission
:CSET:BEEP HL
Sets so that the buzzer of the comparator sounds in HIGH or LOW.
Synta
x
:CSET:BEEPer?
Functio
n
Returns the buzzer mode setting of the comparator table selected by
":CSET:TABLe" command, as OFF, HL, or IN (data).
Respons
e
If headers are ON
If headers are OFF
:CSET:BEEPER data
data
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:CSET:BEEP?
:CSET:BEEPER HL
:CSET:BEEP?
HL
:COMParator?
:CSET:BEEPer
:CSET:BEEPer?