Hioki 3227 - Page 101

89
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Synta
x
:CSET:CMODe data
dat
a
HL, REF (character data)
Functio
n
Sets the comparison method of the comparator table set by ":CSET:TABLe"
command.
Erro
r
The execution error is generated in the following circumstances.
･ There is some conflict in the setting state, when changing the comparison
method of the comparator. However, when the executing comparator table
is invalid, this error is not generated.
･ REF is set while in the temperature conversion display.
Exampl
e
Transmission
:CSET:CMOD HL
Sets the comparison method of the comparator as high limit value or low
limit value.
Synta
x
:CSET:CMODe?
Functio
n
Returns the settings of the comparison method of the comparator set by
":CSET:TABLe" command, as HL or REF (data).
Respons
e
If headers are ON
If headers are OFF
:CSET:CMODE data
data
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:CSET:CMOD?
:CSET:CMODE HL
:CSET:CMOD?
HL
:CSET:CMODe
:CSET:CMODe?