Hioki 3227 - Page 103

91
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Synta
x
:CSET:TABLe data
dat
a
1 to 16 (numerical data in NR1 format)
Functio
n
Select the comparator table set by ":CSET:" command.
When data is set to 16, selects the comparator table using in the
temperature conversion mode.
Erro
r
When not in the temperature conversion mode or if the table number is set
to 16, an excecution error occurs.
Exampl
e
Transmission
:CSET:TABL1
After this, the comparator table number set by ":CSET:" command is 1.
Synta
x
:CSET:TABLe?
Functio
n
Returns the comparator table set by ":CSET:" command, as a numerical
data in NR1 format (data).
Respons
e
If headers are ON
If headers are OFF
:CSET:TABLE data
data
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:CSET:TABL?
:CSET:TABLE 1
:CSET:TABL?
1
Synta
x
:CSET:TMODe data
dat
a
AUTO, EXTernal (character data)
Functio
n
Sets the mode of the external control terminal in the comparator table, set
by ":CSET:TABLe" command.
Exampl
e
Transmission
:CSET:TMOD AUTO
The mode of the external control terminal is set to AUTO.
:CSET:TABLe
:CSET:TABLe?
:CSET:TMODe