Hioki 3227 - Page 104

92
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Synta
x
:CSET:TMODe?
Functio
n
Returns the mode of the external control terminal in the comparator table,
set by ":CSET:TABLe" command, as AUTO or EXTERNAL (data).
Respons
e
If headers are ON
If headers are OFF
:CSET:TMODE data
data
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:CSET:TMOD?
:CSET:TMODE AUTO
:CSET:TMOD?
AUTO
Synta
x
:CSET:USE data
dat
a
ON, OFF (character data)
Functio
n
Sets whether the comparator table, selected by "CSET:TABLe" command, is
valid or not.
Erro
r
When validate the comparator table, in case that there is some conflict in
the setting state, the execution error is generated.
For example, when the comparison method of the comparator is set as high
limit and low limit values, and low limit value of the comparator range is
set bigger than high limit value, the execution error is generated.
Exampl
e
Transmission
:CSET:TABL 1;USE ON
Validate the number 1 comparator table.
Synta
x
:CSET:USE?
Functio
n
Return whether the comparator table which is selected by "CSET:TABLe"
command is valid or not, as ON or OFF (data).
Respons
e
If headers are ON
If headers are OFF
:CSET:USE data
data
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:CSET:USE?
:CSET:USE ON
:CSET:USE?
ON
:CSET:TMODe?
:CSET:USE
:CSET:USE?