Hioki 3227 - Page 106

94
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Synta
x
DELTa:TABLe data
dat
a
0 to 15 (numerical data in NR1 format)
Functio
n
In the temperature conversion mode, specifies the temperature conversion
table as followa;
･ When data is 0, sets the temperature conversion display to be off.
･ When data is 1 to 15, uses the designated table number for the temperatur
e
conversion display.
Erro
r
The execution error is generated in the following circumstances.
･ When the temperature correction function is selected at power on.
･ When the measurement mode is not set to the resistant measurement
mode.
･ When the designated table number is invalid.
･ When one of the values 1 to 15 is specified and no TC sensor is connected.
Exampl
e
Transmission
DELT:TABL 1
The temperature conversion table number 1 is used.
Synta
x
:DELTa:TABLe?
Functio
n
･ Returns current temperature conversion table, as 0 to 15 (data).
･ The setting conditions are as follows.
When data is 0, sets the temperature conversion display to be OFF.
When data is 1 to 15, shows the temperature conversion table number that
is used.
Respons
e
If headers are ON
If headers are OFF
:DELTA:TABLE data
data
Erro
r
The executed error is generated in the following circumstances.
･ When the temperature correction function is selected at power on.
･ The measurement mode is not set to the resistance measurement mode.
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:DELT:TABL?
:DELT:TABL 1
:DELT:TABL?
1
:DELTa:TABLe
:DELTa:TABLe?