Hioki 3541 - Page 149

143
8.6 Message Reference
Trigger Source Setting
Syntax
Command
Query
Response
:TRIGger:SOURce <IMMediate or EXTernal>
:TRIGger:SOURce?
<IMMEDIATE or EXTERNAL>
IMMEDIATE .....Internal triggering
EXTERNAL......External trigger source. Triggering by TRIG key, TRIG
terminal or ∗TRG command.
Example
Command
:TRIG:SOUR IMM
Query
Response
:TRIG:SOUR?
IMMEDIATE
Note
• The following commands do not apply to temperature measurement.
:TRIGger:SOURce
• The HOLD command for the HIOKI 3227 is the same as the
:TRIGger:SOURce EXTernal command.
Trigger Delay Setting
Setting the Trigger Delay Time
Syntax
Command
Query
Response
:TRIGger:DELay <Delay>
:TRIGger:DELay?
<Delay>
Delay [s] .....0 to 9.999 (NR2)
Example
Query
Response
:TRIG:DEL?
0.010
Setting Automatic Trigger Delay
Syntax
Command
Query
Response
:TRIGger:DELay:AUTO <1, 0, ON or OFF>
:TRIGger:DELay:AUTO?
<ON or OFF>
Example
Cancel automatic triggering and set a trigger delay of 0.01 s.
Sending
:TRIG:DEL:AUTO OFF
:TRIG:DEL 10E-3
Query
Response
:TRIG:DEL:AUT?
ON
Note
• The following commands do not apply to temperature measurement.
:TRIGger:DELay
:TRIGger:DELay:AUTO
• When Auto Delay is enabled (:TRIGger:DELay:AUTO ON), the Delay setting is
ignored.