3.2 Operating Flow Overview
39
3
3
Chapter 3 Setting before Measurement
Before measuring, configure the measurement settings on the [Setting] and
[CH] screens. A brief operational description of the currently selected (high-
lighted) setting item appears at
the bottom of the screen.
Three recording methods are available. Ti
med recording, which record
between specified start and stop times, can be used in combination with these
methods (p. 76).
Measurement Configuration (Setting Screen)
Recording Method Description
Normal Recording
Records for the specified recording length beginning
when measureme
nt starts (Cont: Off).
Continuous Recording
Records continuously beginning when measurement
star
ts (Cont: On).
Repeat Recording
Records repeatedly for the specified recording length
(time spa
n) (Rep
eat: On).
. Must be set before measuring.
Make other settings
as needed.
Save automatically
while measuring
(p. 46)
Reloading Settings
(p. 103)
Saving Settings
(p. 102)
Enter a title for mea-
surements (p. 60)
Filter out noise
(p. 45)
Perform numerical
calculations (p. 113)
Record by timer
(p. 76)
Configure recording settings: [Setting] screen
Data recording (acquisition) interval (p. 42)*
Display time base (time per horizontal division) (p. 43)
Recording start/stop method (p. 44)*
Recording length (time span) for repeated or one-time re-
cording (p. 45)*
Horizontal Axis (Time Axis) Settings
To Next Page
Loading...
