Hioki LR8431-20 - Input Channel Settings Configuration

3.2 Operating Flow Overview
41
3
3
Chapter 3 Setting before Measurement
Certain setting items are available on the Waveform screen. Setting details are
the same as for those on the Setting screen.
Measurement Configuration (Waveform Screen)
 Specify the recording interval (data acquisition
interval) (p. 42)
 Specify the display time base (time per hori-
zontal division) (p. 43)
 Enable digital filtering (noise suppression)
(p. 45)
Waveform Screen
Horizontal Axis Settings
 Voltage measurement (p. 50)
 Temperature measurement (p. 51)
 Integration (pulse count) (p. 53)
 Revolution measurement (p. 54)
 Alarm settings (p. 73)
 Setting the display range
Specifying the display position (p. 56)
Specifying upper and lower display limits
(p. 57)
 Select the alarm display type (p. 84)
 Eject (replace the CF card/USB flash drive
during real-time save operation)(p. 48)
 Displaying any point in time (Jump function) 
(p. 83)
Waveform Display Settings
Input Channel Settings
About Channel Settings
Pressing the CH / keys selects channel setting and gauge display items.
However, while measurement data is displayed, such changes affect only those
channels selected (by a check mark [ ]).