Usage Notes
11
About the AC adapter
About the battery pack
Others
• To prevent an electric shock and to maintain the safety specifications of this
instrument, connect the power cord provided only to an outlet.
• Turn the instrument off before connecting the AC adapter to the instrument and
to AC
power.
• Use only the supplied Hioki Model Z1002 AC Adapter. AC adapter input voltage
ran
ge is 100 V AC to 240 V AC (with ±10% stability) at 50 Hz/60 Hz. To avoid
electrical hazards and damage to the instrument, do not apply voltage outside
of this range.
• For battery operation, use only the Hioki Model Z1003 Battery Pack. We do not
take any responsibility for accidents or damage related to the use of any other
batteries.
• To avoid electric shock, turn off the power switch and disconnect the power
cor
d, voltage cord, and current sensor from the object under measurement
before replacing the battery pack.
• To prevent the instrument damage or electric shock, use only the screws for
se
curing the battery cover in place that are originally installed.
If you have lost any screws or find that any screws are damaged, please con-
tact your authorized Hioki distributor or reseller for a replacement.
To avoid problems with battery operation, remove the batteries from the instrument if it
is to be stored several week or more.
The battery pack is subject to self-discharge. Be sure to charge the battery pack before
initial use. If the battery capacity remains very low after correct recharging, the useful
battery life is at an end.
Avoid using an uninterruptible power supply (UPS) or DC/AC inverter with rectangular
wave or pseudo-sine-wave output to power the instrument. Doing so may damage the
instrument.
To Next Page
Loading...
