Hioki PQ3198 - Page 82

5.2 Changing the Recording Settings
76
Sets the type of measurement data.
See:"Key operation during configuration" (p.75)
Note: If 400 Hz is selected, [All data]∗ can not be selected.
Recording Items
Setting Contents:( ∗ : Default setting)
All data∗
Records all the calculation values.
Power and Harmonic Records all calculation values except inter-harmonics.
Power Records all calculation values except harmonics and inter-harmonics.
Recording items Power Power and
Harmonic
All data Recording items Power Power and
Harmonic
All data
RMS voltage
refreshed each
half-
cycle
  
Instantaneous flicker
value
  
RMS current
refreshed each
half-cycle
  
Integral power
  
Frequency
200 ms
  
Harmonic voltage
—
 
Frequency wave
  
Harmonic current
—
 
10-sec
frequency
  
Harmonic power
—
 
Voltage RMS
  
Phase difference of
harmonic voltage and
harmonic current
—
 
Current RMS
  
High-order harmonic
voltage phase angle
—
 
Voltage
waveform peak
  
High-order harmonic
current phase angle
—
 
Current
waveform peak
  
Inter-harmonic voltage
— —

Active power
  
Inter-harmonic current
— —

Apparent Power
  
THD Voltage Percentage
  
Reactive Power
  
THD current percentage
  
Power factor/
displacement
power factor
  
High-order harmonic
voltage component
  
Efficiency
  
High-order harmonic
current component
  
Voltage
unbalance factor
  
K factor
  
Current
unbalance factor
  
Flicker
(Δ
V10/ Pst, Plt)
  
Detailed trend graphs are always displayed with maximum and minimum values.
HIOKI PQ3198A961-02