5.10 Viewing Waveforms
96
Changing the Zoom Factor for the Vertical Axis Used to Display
Voltage and Current Waveforms
1
Press the [MAGNIFY] key.
The cursor will move to the zoom factor field, and you will be able to change
the setting.
2
Move the cursor to the voltage or
current zoom factor and press the
[ENTER] key.
A dialog box for selecting the zoom
factor will be displayed.
3
Select the desired zoom factor with the cursor’s keys and
press the [ENTER] key.
• For 1P2W x 2 or 1P2W x 3 wirings, changes to the vertical axis
zoom factor will affect all channels, even if individual channels
use different clamp sensors or current ranges.
• For 3P3W3M wirings, the phase voltage from the virtual neutral
point is displayed as the voltage waveform, but the line-to-line
voltage is displayed as the voltage (RMS).
To Next Page
Loading...
