2.2 Preparing to Use the Instrument after Purchase
26
5
Insert the connector from the battery pack
into the port on the instrument.
Take care to orient the connector properly and in-
sert it as far as it will go.
6
With the battery case facing down, fit it
into the recessed area on the instrument.
Exercise care not to pinch the battery pack’s wires
between the battery case and the instrument.
7
Install the battery case onto the instru-
ment using the four dedicated screws
(M3×25 mm) that come with Model PW9002
Battery Set.
8
Connect the AC adapter to the instrument to charge the battery pack.
The battery pack will be charged regardless of whether the power is on.
Charge LED
On (red): Charging
Off: Fully charged/when the bat-
tery pack is not attached
Left side of the PW3360
To Next Page
Loading...
