Hioki PW3360-21 - Page 4

Contents
ii
Chapter 3
Connecting to Lines to be Measured ___________41
3.1 Connection Procedure ........................................... 42
3.2 Setting Measurement Conditions on the Wiring 
Diagram Screen ...................................................... 43
3.3 Connecting the Voltage Cords .............................. 47
3.4 Connecting a Clamp Sensors ................................ 49
3.5 Connecting the Voltage Cords to Lines to be 
Measured ................................................................. 51
3.6 Connecting Clamp Sensors to Lines to be 
Measured ................................................................. 52
 Load Current Measurement .............................................52
 Leakage Current Measurement .......................................53
3.7 Setting the Current Range ..................................... 54
3.8 Verifying Correct Wiring (Wiring Check) .............. 56
Chapter 4
Changing Settings __________________________61
4.1 Viewing and Using the Settings Screen ............... 62
4.2 Changing Measurement Settings .......................... 63
 Measurement 1 Setting Screen .......................................63
 Measurement 2 Setting Screen .......................................65
4.3 Changing Recording (Save) Settings ................... 69
 Recording 1 Setting Screen .............................................69
 Recording 2 Setting Screen .............................................74
4.4 Changing System Settings (as Necessary) .......... 77
 System 1 Setting Screen .................................................77
 System 2 Setting Screen .................................................79
4.5 Initializing the Instrument (System Reset) ........... 80
 Reverting the Instrument to Its Factory Settings 
(Factory Reset) ................................................................81
4.6 Factory Settings ...................................................... 82