Hioki PW3390 - Saving Noise Data and Waveform Data; Saving Noise Data

7.6 Saving Noise Data and Waveform Data
145
89
7
Chapter 7 Data Saving and File Operations
This operation saves the waveform displayed on the [Wave + Noise] page as a CSV file.
7.6 Saving Noise Data and Waveform Data
7.6.1 Saving Noise Data
Saving Procedure
Display the
[
Wave + Noise]
page
(Saves the noise waveform
at this moment)
Save destination: CF card, USB flash drive
(Save destination setting is the same as for Manual saving (p. 139))
File names: Auto generated, with CSV extension
F3390nnn.CSV ("nnn" is serial number 000 to 999 within the same folder)
Example: F3390000.CSV
• Data is saved for channels for which noise analysis calculations have been enabled.
• Noise waveforms cannot be saved during auto-saving operation.
• Voltage noise and current noise are saved together as noise waveform data for each
frequency being analyzed.
See "4.6 Viewing Noise Measurement Values (FFT Function)" (p. 83)