Hioki PW3390 - Configuring and Connecting the Adapter

8.4 Connecting the Instrument to a LR8410 Link-compatible Logger
173
8
Chapter 8 Connecting External Devices
1. Set the Bluetooth

serial conversion adapter’s communications speed.
The speed is set with DIP switches.
2. Affix the Bluetooth

serial conversion adapter to the instrument’s D-sub 9-pin connector.
8.4.1 Configuring and Connecting the Adapter
Setting procedure
Display the
[Interface] page
Select
[RS com speed]
Choose the same com-
munications speed as
was set with the adapt-
er’s DIP switches.
Select with the F keys
Select
[Adapter conf.]
Initialize the adapter (see chart below).
Perform this step when connecting the adapter for the first time after purchase.
Device name PW3390#nnnnnnnnn:HIOKI
(where n indicates the 9-digit serial number)
Operation mode Mode3
(Causes the adapter to stand by for connections from all Bluetooth

devices.)
Pin code 0000
Response Unused
Escape sequence characters Not permitted
• For more information about how to configure Hioki LR8410 Link-compatible loggers such as
the LR8410, see the instruction manual for the logger with which you wish to use the instru-
ment.
• Changing the instrument’s measurement range while its measured values are being automat-
ically saved by an LR8410 Link-compatible logger will prevent the logger from saving the val-
ues properly. Set the measurement range on the instrument with the manual range setting
before initiating auto-saving. When auto-saving is started, the auto-range settings for all chan-
nels will turn off.
• The output parameters for LR8410 Link-compatible loggers are the same as the output
parameters for D/A output channels 9 through 16 (D/A9 to D/A16).
See "8.3.2 Output Item Selection" (p. 166).