Hioki PW3390 - 8.5 Using the Motor Testing

8.3 Using Analog and Waveform D/A Output
166
Select the items for D/A output. Up to 16 items can be selected.
Make the settings on the [D/A Out] page of the Setting screen.
Freq f.s. Set this to output frequency in the analog output.
For models equipped with motor analysis functionality, this is the same as the maximum
motor measurement frequency setting. ("Max frequency" (p. 101))
Integ f.s. Set for analog outputs. ("About Full-Scale Integration" (p. 167))
Output range Set the output voltage value for full scale input when waveform is output.
8.3.2 Output Item Selection
Setting Procedure
(the pull-down menu appears)
Display the
[D/A Out] page
Select
[Wave output]
ON: Enable waveform output
OFF: Disable waveform out-
put
Select a channel
to be set.
Select parameter
items
(sub parameter last)
Enter: or
Cancel: or
Main parameter
Sub parameter
Pull-Down Menu
Select the main and sub
parameter.
Select with the F keys
100 Hz, 500 Hz, 1 kHz, 5 kHz
1/10, 1/2, 1/1, 5, 10, 50, 100, 500, 1000, 5000, 10000
1 V f.s., 2 V f.s.