Hioki PW3390 - Connecting the Voltage Measurement Cables; Connecting the Current Sensors

3.6 Connecting the Voltage Measurement Cables
30
Be sure to read the "Usage Notes" (p. 7) before connecting measurement cables.
Plug the voltage measurement cable leads into the voltage measurement jacks on the instrument (the
number of connections depends on the lines to be measured and selected wiring mode).
Be sure to read the "Usage Notes" (p. 7) before connecting measurement cables.
Plug the current sensor cables into the current measurement jacks on the instrument (the number of con-
nections depends on the lines to be measured and selected wiring mode). See the instruction manual
supplied with the current sensor for specification details and usage procedures.
3.6 Connecting the Voltage Measurement
Cables
Connection Procedure
Insert each voltage cable into the jack with the same color as the
indicated channel.
Insert the plugs into the terminals as far as they will go.
3.7 Connecting the Current Sensors
Connection Procedure
1
Align the guide position of the connector.
2
Push the connector straight in until it locks in place.
The instrument will automatically recognize the current
sensor type.
Align so that the thick band is positioned
at the top of the instrument (facing up).
Grip the top of the metal portion.
Disconnecting the current sensors
1
Grip the metal portion of the connector and slide it
toward you to disengage the lock.
2
Pull out the connector.
Grip the metal portion.