Right side
Ethernet interface jack
For LAN connection with an
Ethernet cable.
See p. 180
Sync interface
For synchronizing cables, as
needed.
See p. 157
Vent
Keep clear of obstructions.
See p. 7
RS-232C interface
For RS-232C cable connection, as needed.
See p. 185
USB port
For the supplied USB cable,
as needed.
See p. 184
Rear side
Voltage input terminals
Connect Hioki-specified voltage
measurement cables.
See p. 30,
"Usage Notes" (p. 7)
Current input terminals
Connect an Hioki-specified cur-
rent sensor.
See p. 30,
"Usage Notes" (p. 7)
Power inlet
Connect the supplied power
cord.
See p. 29,
"Usage Notes" (p. 7)
Output terminal
Connect the supplied D-sub plug (PW3390-02
[model with D/A output] and PW3390-03 [mod-
el with motor analysis and D/A output] only).
See p. 164
CH A torque signal input BNC jack
Connect the Hioki L9217 BNC connection cable to
this terminal (PW3390-03 [model with motor anal-
ysis and D/A output] only).
See p. 174,
"Usage Notes" (p. 7)
CH B and CH Z rotation signal
input BNC jacks
Connect the Hioki L9217 Connection
Cord to these terminals (PW3390-03 [mod-
el with motor analysis and D/A output] only).
See p. 174,
"Usage Notes" (p. 7)
Serial No.
This is the instrument’s serial
number.
Functional ground terminal
Connect this terminal to a clean
common ground to suppress elec-
trical noise when measuring in an
electrically noisy environment.
See p. 29
To Next Page
Loading...
