Hioki PW3390 - Page 58

4.2 Viewing Power Measurements, and Changing the Measurement Configuration
50
Press . The screen shows settings for Wiring mode 7, (3 phase 3 wire (3P3W3M)+1 phase 2 wire
(1P2W)).
Press . The screen shows settings for Wiring mode 7, (3 phase 3 wire (3P3W3M)+1 phase 2
wire (1P2W)).
Displaying Voltage
Displaying Current
RMS Voltage
Rectified Mean Value of
RMS Conversion
THD Voltage Percentage*
Fundamental Voltage
Content
Voltage Waveform Peak+
AC Voltage Content
Frequency
Simple Averaged Voltage
Voltage Waveform Peak-
When the Wiring mode is 3P3W3M or 3P4W, voltage unbalance Uunb [%] is displayed.
* When the integration mode is set to DC, the voltage ripple rate Urf [%] will be displayed instead of
the voltage total harmonic distortion.
RMS Current
Rectified Mean Value of
RMS Conversion
THD Current Percentage*
Fundamental Current Content
Current Waveform Peak+
AC Current Content
Simple Averaged Current
Current Waveform Peak-
When the Wiring mode is 3P3W3M or 3P4W, current unbalance Iunb [%] is displayed.
* When the integration mode is set to DC, the current ripple rate Irf [%] will be displayed instead of the
current total harmonic distortion.
Frequency