6 Optional functions
224
SMGB0077 rev.0 - 01/2013
Selection of another indoor unit
In optional function setting mode, press TEMP ▲ or TEMP ▼ on the remote control to select the indoor unit on which the
optional function is to be set.
6.3.2 List of optional remote control functions
Element Optional function
Individual
setting
Settings Condition setting Description
b1
Removal of heating
temperature compensation
O
00
Standard setting.
It increase the
temperature +4ºC
This function is used when the
temperature setting displayed on the
remote control and the supply air
temperature of the indoor unit must be
the same.
01 Removal
02
It increase the
temperature +2ºC
(1)
.
b2
Circulator function at heating
Thermo- OFF
O
00
Not activated
function
This function means that the unit
fan remains running after the air
conditioning system has stopped
to prevent the air in the room from
stratifying.
01 Activated function
b3
Forced compressor operation
for at least three minutes
O
00
Not activated
function
This function is used to protect the
compressor, preventing it from being
started or stopped for periods of less
than three minutes.
01 Activated function
b4
Pre-determined lter cleaning
period change
O
00 Standard
This function is used to modify the
period which the remote control
indicates the air lter replacement.
01 100 hours
02 1200 hours
03 2500 hours
04 Not used
b5
Fixing of operation mode X
00
Not activated
function
Once the unit operating mode has
been selected, this function prevents
it from being modied from the remote
remote control.
01 Activated function
b6
Fixing of setting temperature X
00
Not activated
function
Once the unit temperature has been
selected, this function prevents it
from being modied from the remote
control.
01 Activated function
b7
Fixing of cooling operation X
00
Not activated
function
This function is available to use
cooling mode only and to prevent
heating mode from being enabled.
01 Activated function
b8
Automatic COOL/HEAT
operation
X
00
Not activated
function
This function allows the automatic
change from the cooling to the heating
mode for the units with the same
refrigerant cycle.
01 Activated function
b9
Fixing of fan speed X
00
Not activated
function
Once the unit fan speed has been
selected, this function prevents it
from being modied from the remote
control.
01 Activated function
bA
Not available X
“- -”
permanent
Not available –
To Next Page
Loading...
Need help?
General
