6 Optional functions
239
6
SMGB0077 rev.0 - 01/2013
FC – Cooling lower limit for setting temperature
This function is useful to set the temperature range in cooling mode. It enables the cooling range to be reduced for
conguration using the remote control.
An example is shown in the following gure:
Fd – Heating upper limit for setting temperature
This function is used to dene an upper temperature setting limit for the HEAT function. This function enables the heating
range to be reduced for conguration using the remote control.
An example is shown in the following gure:
FE – Not available
FF – Lock function for timer (PC-ART) / Not available (PC-ARF)
This function is used to lock timer activation.
H1 – Maintenance alarms (PC-ART) / Not available (PC-ARF)
This function is used to display or hide maintenance alarms.
H2 – Automatic control indication (PC-ART) / Indication of hot start (PC-ARF)
This function is used to display or hide the automatic control indication.
H3 – Operation mode change restriction (PC-ART) / Not available (PC-ARF)
This function is used to congure restrictions to the HEAT mode.
H4 – Operation modes for the ventilation unit with energy / heat recovery (PC-ART) / Not available
(PC-ARF)
This function is only available for the ventilation unit with energy / heat recovery.
H5 – Central control available after forced stoppage / Not available (PC-ARF)
This function allows for central control after the forced stoppage of the unit.
To Next Page
Loading...
