Thread on the nuts and îš¿t the washers for all the bolts, as shown in the îš¿gure.
Fit two suspension brackets onto the nut and washer of each bolt, starting on one side.
Check that the nuts and washers are correctly secured with the suspension bracket retainers and îš¿t the brackets onto their
nuts and washers on the other side.
Fit the washers with the insulation facing downwards, as shown in the îš¿gure. Bear in mind the position of the side for pipe
connection before lifting the indoor unit.
Where a false ceiling is already installed, install and prepare the pipes and cables on the indoor unit before lifting it.
C A U T I O N
• Before lifting the unit, prepare any necessary means (ladders, scaffolding, elevator platform, etc.) and check
that the current safety regulations in the place where the installation is taking place are met.
• Check that the lifting work can be carried out without the risk of injuries to you or others in the surrounding
area.
• Request the assistance of another person to lift the unit.
Lift the unit carefully, without exercising pressure on the drain pan.
Fit the nuts, at washers and spring washers supplied (4 of each)
to secure the indoor unit.
Check that the condensate discharge system in the indoor unit
works correctly. To do so, check the level of the drain pan using a
spirit level.
Adjusting the space between the indoor unit and the opening in the false ceiling
Adjust the indoor unit to the correct position using the pattern for
the installation.
To Next Page
Loading...
Need help?
General
