Honeywell ACUIX - Figure C-6 AE Control Menu and Example Settings; Table C-2 Auto Exposure Control Mode Settings

ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Document 800-05662V1 Rev A 105
04/11
Figure C-6 AE Control Menu and Example Settings
Note the following about using NightShot with a 35× camera block.
• AER+1 mode is optimized for signal-to-noise (S/N) ratio priority.
• AER+3 mode is optimized for color priority.
• AER+2 mode is balanced between S/N ratio and color priorities.
• To see a depiction of the approximate light levels where the camera
switches from day mode (IR cut filter in) to night mode (IR cut filter out) and
then from night mode to day mode, see
• Figure C-7 for when the digital slow shutter function is inactive.
• Figure C-8 for when the digital slow shutter function is active.
• The conditions for the change from day to night mode must be
continuously present for more than 5.0 s for the switch to take place.
• The conditions for the change from night to day mode must be
continuously present for more than 8.0 s for the switch to take place.
The exposure mode is toggled between auto and manual using preset 92 if the
ACUIX is configured for MAXPRO-mode, Diamond protocol, VCL protocol, VCL
UTC protocol, Pelco P protocol, or Pelco D protocol. If the camera is in manual
exposure control mode preset 94 toggles between day and night NightShot
(TDN) modes.
PROGRAM AE CONTROL MENU
Auto Exp OFF for Manual AE
1 Auto AE Mode............AE
2 NA
3 NA
AE Exp. Mode Features
NightShot Control........MAN
Auto NS Sensitivity.......NA
Digital Slow Shutter.....OFF
Table C-2 Auto Exposure Control Mode Settings
Setting NightShot
Control
Auto
NightShot
Sensitivity
Digital Slow
Shutter
Auto AE Mode MAN NA OFF
Auto AER1 Mode AUTO HIGH OFF
Auto AER2 Mode AUTO MID OFF
Auto AE+ Mode MAN NA AUTO
Auto AER+1 Mode AUTO HIGH AUTO
Auto AER+2 Mode AUTO MID AUTO
Auto AER+3 Mode AUTO LOW AUTO