24
Configuring PTZ Control
Setting Auto Pivot
Auto pivot lets you track subjects passing under the dome in a single continuous
shot. When auto pivot is enabled and the controller joystick is held in the down
position, the camera automatically turns 180 degrees when it reaches its lower
limit and continues tracking up the other side.
To enable/disable auto pivot:
• Select 3 Control Options
2 Auto-Pivot ON or OFF (default).
Setting the Pan and Tilt Speed
You can manually set the maximum pan and tilt speed settings of the camera.
The following maximum pan speeds are available:
• 120 degrees per second
• 240 degrees per second
• 480 degrees per second
The maximum tilt speed is determined by the maximum pan speed, being half of
the maximum pan speed: 60, 120, or 240 degrees per second.
To manually set the maximum pan and tilt speed:
• Select 3 Control Options
4 Set Pan and Tilt Options 1 Manual
Speed deg/s
120, 240, or 480 (default).
Setting Pan Reverse
You can reverse the pan so that a left pan command from the controller will
cause the camera to pan right and a right pan command will cause the camera
to pan left.
To enable/disable pan reverse:
• Select 3 Control Options
4 Set Pan and Tilt Options 2 Pan Reverse
ON or OFF (default).
To Next Page
Loading...
