Honeywell ACUIX - 11 System Administration and Equipment Handling; Configuring Pins and Passwords

Document 800-05662V1 Rev A 81
04/11
11
System Administration and Equipment
Handling
This chapter contains the following sections:
• Configuring PINs and Passwords , page 81
• Resetting the Dome , page 82
• Restoring the Default Settings , page 83
• Changing the Dome Address, Protocol, Parity, and Baud Rate Settings , page 83
• Sending Commands to All Domes , page 84
• Maintaining the Dome , page 85
Configuring PINs and Passwords
To enable/disable the user login PIN:
1. Enter preset 75 on your controller.
2. Enter the 4-digit PIN. The default PIN is 1000.
3. Select 1 User Login PIN
 Enabled or Disabled (default).
To change the user login PIN:
1. Enter preset 75 on your controller.
2. Enter the 4-digit PIN. The default PIN is 1000.
3. Select 2 Change PIN.
4. Enter a new 4-digit PIN.
5. Re-enter the PIN to verify. If both PINs match, the message
PIN changed is
displayed and the Password Settings menu opens.