64
Configuring Presets, Tours, Privacy Zones, and Sectors
Note If you are using a Pelco controller, mimic tours 1, 2, and 3 are
mapped to patterns 0, 1, and 2 respectively.
Using Diamond/IntelliBus protocol:
1. Select Preset
6 Function Programming 1 PTZ Mimic Tour Menu
1 Run a Tour.
2. Enter the number of the mimic tour you want to run.
Stopping a Mimic Tour
You can stop any mimic tour by manually controlling the dome or by sending the
dome to a preset, preset tour, or other mimic tour.
Deleting a Mimic Tour
Using MAXPRO-mode/VCL/VCL UTC/Pelco P/Pelco D protocol:
1. Select 6 Function Programming
7 Delete PS/PT/MT/ Sectors.
2. Press Focus Near to scroll to Delete Mimic Tour #.
3. Enter the number of the mimic tour you want to delete. If the deletion is
successful, the message
Delete Success appears.
Using Diamond/IntelliBus protocol:
1. Select Preset
6 Function Programming 1 PTZ Mimic Tour Menu
3 Delete Mimic Tour.
2. Enter the number of the mimic tour you want to delete. If the deletion is
successful, the message
Delete Success appears.
To Next Page
Loading...
