60
Configuring Presets, Tours, Privacy Zones, and Sectors
Programming a Preset Tour
These instructions apply only to domes configured for MAXPRO-mode, VCL,
VCL UTC, Pelco P, or Pelco D protocol.
You can program up to 16 preset tours of up to 64 presets each.
To program a preset tour:
1. Select 6 Function Programming
2 Program a Preset Tour.
2. The Number (NUM) column shows the order in which the presets will be
processed.
3. In the Preset column, enter the number of the preset you want to use.
4. In the Velocity column, select a value (in degrees) between 1 and 480
(default = 480 degrees per second).
5. In the Dwell column, select a value (in seconds) between 1 and 99.
Note Press Focus Near to insert a new line above the current line.
Press Focus Far to delete the current line.
Setting Preset Tour Auto Focus
You can turn auto focus on or off for preset tours. When auto focus is disabled,
the camera lens does not attempt to focus while moving between presets.
To enable/disable preset tour auto focus:
• Select 3 Control Options
7 Preset Tour Auto Focus ON or OFF
(default).
Note Preset tour auto focus is turned on automatically when preset auto
focus is turned on. Preset tour auto focus cannot be turned off while
preset auto focus is on.
To Next Page
Loading...
