48
Configuring HDXG Camera Settings
To enable/disable vertical phase edge:
• Select 5 Camera Options
6 Vert Phase Edge Enabled or Disabled
(default).
To set the vertical phase edge:
1. Enable vertical phase edge.
2. Select 5 Camera Options
7 Vert Phase 0–359.9.
3. Select a value between 0 (default) and 359.9. The value expresses, in
degrees, the adjustment required overcome the difference between
connected AC supply phases.
Setting Image Stabilization
Electronic image stabilization (EIS) compensates for camera vibration,
minimizing image blur.
To enable/disable image stabilization:
• Select 5 Camera Options
3 Video Setup 8 Image Stabilization
5Hz, 10 Hz, or OFF (default).
Note If image stabilization is enabled, the digital zoom is restricted to 2×.
Setting Motion Detection
When motion detection is enabled, any detected motion causes the message
Motion Detected to be displayed on the monitor. The message remains on the
screen until the dome receives a pan, tilt, or zoom command.
Motion detection is automatically disabled as soon as motion is detected to
avoid multiple triggers from the same event. It is turned on again after a one
minute delay.
Pan, tilt, or zoom changes will disable motion detection.
To Next Page
Loading...
